PROGRAM > PolysixEX: Modulation & Arpeggiator 5–1: Mod & Arp
291
PROGRAM > PolysixEX: Modulation & Arpeggiator
5–1: Mod & Arp
5–1a: EXTERNAL MODULATION
The External Modulation section offers an easy way to
assign modulation to multiple destinations at once, using any
AMS source. Note that most parameters also include
dedicated AMS modulation, via the Parameter Details area.
Source 1
SOURCE 1 [List of AMS Sources]
This selects the modulation source to control the parameters
below. For a list of AMS sources, see “Alternate Modulation
Source (AMS) List” on page 901.
VCO PULSE WIDTH [–10.00…+10.00]
Specifies the depth and direction of the modulation applied
to the oscillator (VCO) PW/PWM.
VCF CUTOFF [–10.00…+10.00]
Specifies the depth and direction of the modulation applied
to the filter (VCF) CUTOFF.
VCA GAIN [–10.00…+10.00]
Specifies the depth and direction of the modulation applied
to the amp (VCA).
MG LEVEL [–10.00…+10.00]
Specifies the depth and direction of the modulation applied
to the MG (Modulation Generator) LEVEL.
Source 2
This allows you to route a second AMS source to the same
list of mod destinations. The parameters are identical to
those under “Source 1,” above.
5–1b: ARPEGGIATOR
ON/OFF [Off, On]
Switches the arpeggiator on/off.
KEY SYNC [Off, On]
If this setting is ON, the arpeggiator will be reset at the
beginning of each legato phrase.
This parameter is not modulatable.
TEMPO SYNC [Off, On]
Touch the text/LED area to turn TEMPO SYNC on and off.
On (LED lit): When TEMPO SYNC is On, the arpeggiator
synchronizes to the system tempo, as set by either the Tempo
or MIDI Clock. The arpeggiator speed is controlled by the
combination of the BASE NOTE and SPEED/TIMES
parameters, below.
Off (LED dark): When TEMPO SYNC is Off, the
FREQUENCY/TIMES knob determines the speed of the
arpeggiator, and the BASE NOTE setting has no effect.
This parameter is not modulatable via AMS.
BASE NOTE [1/1…1/32]
When TEMPO SYNC is ON, this sets the basic speed of the
arpeggiator, relative to the system tempo. The values range
from a 32nd note to a whole note, including triplets. This
value is then multiplied by the SPEED/TIMES knob,
below.
When TEMPO SYNC is OFF, this parameter has no effect.
BASE NOTE is not modulatable via AMS.
To Next Page
Loading...
Need help?
General
