SEQUENCER mode
466
SEQUENCER > EQ/X-Y/Controllers
1–1: MIDI Track EQ
Each Track has a dedicated three-band EQ, with sweepable
mid band. This page lets you view and adjust the settings for
all 16 MIDI Tracks at once.
1–1a: Location, Song/Track Select
Location [001:01.000…999:16.479]
Song Select [000…199]
Track Select [MIDI Track01…MIDI Track16,
Master Track, Audio Track01…Audio Track16]
RPPR [Off, On]
(Tempo) [040.00…300.00, EXT]
For more information, please see “0–1a: Location,
Song/Track Select” on page 443.
1–1b: Selected Track Info
This page displays information about the track that’s
selected for editing. If you’ve selected a MIDI track, this
shows the bank type, T: MIDI track number/program
bank/number/name, Ch: MIDI channel number, RPPR
(Assign): the key number that starts the RPPR assigned to
the track, and KBD: the bank/number/name of the program
that will sound when you play the keyboard.
If you’ve selected an audio track, this shows the AT: audio
track number/region number and name of the first audio
event, [STEREO]: Stereo Pair on/off status, and KBD: the
bank/number/name of the program that will sound when you
play the keyboard.
RPPR (Assign) will not show all of the RPPR assignments if
there are many of them. You can use the Pattern Edit page to
see all of the RPPR assignments.
Track Number
This indicates the MIDI track number. The various
parameters below each track number make settings for the
corresponding track.
Track Category
This shows the abbreviated category name of the Program
assigned to the Track.
Track 01 (Track Number)
Auto Load Prog EQ [Off, On]
When you first load a Program into a Track, this parameter
determines whether or not the Program’s EQ settings will be
loaded as well.
Once the Program has been loaded, you can change any or
all of the EQ settings as desired. All such edits are stored in
the Combination, without affecting the original Program.
Regardless of this setting, subsequent edits to the Program’s
EQ in PROGRAM mode will not affect the Combination.
On: the Program’s EQ settings will be loaded automatically
along with the Program. This is the default setting.
Off: the Program’s EQ settings won’t be loaded. Use this if
you’ve set up the EQ in a specific way, and then want it to
stay unchanged while you try out different Programs.
Bypass [Off, On]
If this is On (checked), all of the EQ will be disabled,
including “Input Trim.” Bypass can be convenient for
comparing the results of the EQ with the original signal.
Selected Track Info
Track Number
Track Category
To Next Page
Loading...
Need help?
General
