872
134: Wah - Amp Sim
This effect combines a mono wah and an amp simulation.
You can change the order of the effects.
Routing
Routing [Wah > Amp, Amp > Wah]
Switches the order of the wah and amp simulation.
WAH
For detailed information, see “WAH” on page 861.
AMP SIM
Amplifier Type [SS, EL84, 6L6]
Selects the type of guitar amplifier.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
135: Decimator - Amp Sim
This effect combines a mono decimator and an amp
simulation. You can change the order of the effects.
Routing
Routing [Decimator > Amp, Amp > Decimator]
Switches the order of the decimator and amp simulation.
DECIMATOR
Pre LPF [Check-box]
Turn the harmonic noise caused by lowered sampling on and
off. See “Pre LPF” on page 785.
Sampling Frequency [Hz] [1.00k…48.00k]
Sets the sampling frequency.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation.
BIT SHAPE
For more information on these parameters, see “Resolution
[bits]” on page 785.
Resolution [bits] [4…24]
Sets the data bit length.
Output Level [0…100]
Sets the decimator output level.
AMP SIM
Amplifier Type [SS, EL84, 6L6]
Selects the type of guitar amplifier.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Wet / Dry
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Routing
Amp Simulation
Amp Simulation Filter
Wah/Auto Wah
Wah
D
-mod
Envelope
Sweep Mode
D-mod
Auto
LFO
LFO
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Decimator
Routing
Amp Simulation
Amp Simulation Filter
Pre LPF
High Damp
Output Level
Decimator
Resolution
To Next Page
Loading...
Need help?
General
