PROGRAM > OSC/Pitch 2–5: OSC2 Basic
57
Mode [Constant Rate, Constant Time]
Constant Rate means that Portamento will always take the
same amount of time to glide a given distance in pitch - for
instance, one second per octave. Put another way, gliding
several octaves will take much longer than gliding a half-
step.
Constant Time means that Portamento will always take the
same amount of time to glide from one note to another,
regardless of the difference in pitch. This is especially useful
when playing chords, since it ensures that each note in the
chord will end its glide at the same time.
Time [000…127]
This controls the portamento time. Higher values mean
longer times, for slower changes in pitch.
This option is only available when Portamento Enable is
turned on.
Assigning SW1 or SW2 to Portamento On/Off
You can use the two assignable switches, SW1 and SW2, to
turn portamento on and off.
To do so:
1. Go to the PROGRAM > Basic/X-Y/Controllers–
Switch page.
2. Under Switch, set either Switch1 or Switch2 to
Portamento SW (CC#65).
Now, the selected button will enable and disable Portamento.
It will also send the MIDI Portamento controller, CC#65.
Even if you don’t assign SW1/2 to Portamento, you can
still use MIDI Controller #65 to turn Portamento on and
off.
v
2–2: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy Oscillator →p.119
• Swap Oscillator →p.119
•PAGE →p.126
•MODE →p.126
2–5: OSC2 Basic
This page controls the basic settings for Oscillator 2. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “2–1: OSC1 Basic,” on page 50.
2–6: OSC2 Pitch
This page controls the pitch settings for Oscillator 2. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “2–2: OSC1 Pitch,” on page 55.
To Next Page
Loading...
Need help?
General
