Delay 085: Tape Echo
839
085: Tape Echo
This effect models a tape echo unit with three playback
heads, including the distortion and tonal changes typical of
magnetic tape.
INPUT
Trim [0…100]
Sets the input gain.
Pre Tone [0…100]
This models the reduced high frequencies of an analog tape
delay, before the saturation stage. Lower settings create a
darker tone.
WOW & FLUTTER
This section models the instability of the tape machine’s
motors. As the speed of the motor fluctuates, the pitch
changes slightly. This introduces a pleasant chorus-like
effect.
Frequency [Hz] [0.02…1.00]
Sets the frequency at which pitch variation occurs.
Depth [0…100]
Sets the depth of the pitch change.
TAPE ECHO
Delay Time
Delay Time(Tap1) [msec] [0…2700]
This parameter sets the delay time of Tap 1.
Also, Taps 2 and 3 are specified as a percentage (%) of this
delay time. Taps 2 and 3 always stay in proportion to Tap 1,
even when the delay time is modulated.
Source [Off…Tempo]
Selects the modulation source for the delay time.
Amount [–2700…] +2700
Sets the modulation amount for the delay time.
Tap2 Position [%] [0…100]
Sets the delay time of Tap 2, as a percentage of Tap 1’s delay
time.
Tap3 Position [%] [0…100]
Sets the delay time of Tap 3, as a percentage of Tap 1’s delay
time.
Level and Pan 1…3
Each tap has its own controls for level and pan.
Tap1…3 Level [0…100]
Sets the tap’s output level.
Pan [L, 1…99, R]
Sets the tap’s stereo position.
Feedback
Tap1…3 Feedback Amount [+/–100]
Sets the individual tap’s feedback level. Negative values
invert the phase. These individual levels are summed
together, and then the final level is controlled by Feedback
Level, below.
Feedback Level [0…100]
Sets the overall level of feedback.
Source [Off…Tempo]
Selects the modulation source for the Feedback Level.
Amount [+/–100]
Sets the modulation amount for the Feedback Level.
Tone
High Damp [%] [0…100]
This cuts the high frequencies in both the main output and
the feedback. Higher settings create a darker tone.
Low Damp [%] [0…100]
This cuts the low frequencies in both the main output and the
feedback. Higher settings mean less low-end.
Saturation [0…100]
This models the distortion of an analog tape delay.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Wah Flatter
D
-mod
Tap2/3
Position
+
Tape
Saturation
Left
Right
Wet / Dry
Trim
PanLevel
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Feedback
Feedback Amt
High / Low DampPre Tone
Delay
(1)
(2)
(3)
Delay Time
To Next Page
Loading...
Need help?
General
