Korg NAUTILUS Series

Mono-Mono Serial 136: Decimator - Comp
873
136: Decimator - Comp
This effect combines a mono decimator and a compressor.
You can change the order of the effects.
Routing
Routing [Decimator > Comp, Comp > Decimator]
Switches the order of the decimator and compressor.
DECIMATOR
Pre LPF [Check-box]
Enables and disables a filter which prevents aliasing noise.
See “Pre LPF” on page 785.
Sampling Frequency [Hz] [1.00k…48.00k]
Sets the sampling frequency.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation.
BIT SHAPE
For more information on these parameters, see “Resolution
[bits]” on page 785.
Resolution [bits] [4…24]
Sets the data bit length.
Output Level [0…100]
Sets the decimator output level.
COMPRESSOR
For detailed information, see “COMPRESSOR” on
page 860.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
137: Amp Sim - Tremolo
This effect combines a mono amp simulation and a tremolo.
AMP SIM
Amplifier Type [SS, EL84, 6L6]
Selects the type of guitar amplifier.
TREMOLO
LFO
Waveform [Triangle, Sine, Vintage, Up, Down]
Selects the LFO Waveform. See “Waveform” on page 817.
Shape [+/–100]
Changes the curvature of the LFO Waveform. See “Shape”
on page 782.
Frequency [Hz] [0.02…20.00]
Sets the LFO speed.
TREMOLO
Depth [0…100]
Sets the depth of LFO modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Decimator
Routing
Pre LPF
High Damp
Output Level
Decimator
Resolution
Compressor
Comp
Output Level
Envelope - Control
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Amp Simulation Tremolo
Amp Simulation Filter
Tremolo
LFO: Tri/Sin/Vintage/Up/Down
LFO Shape