810
053: Stereo Envelope Phaser
This stereo phaser uses an envelope generator for
modulation. You will obtain the same pattern of phasing
each time you play. You can also control the Phaser directly
using the modulation source.
PHASER
L Manual Bottom [0ā¦100]
Sets the lower limit of the left-channel phaserās sweep.
For more information on the Bottom and Top settings, see
the graphic under āFrequency Bottomā on page 779.
L Manual Top [0ā¦100]
Sets the upper limit of the left-channel phaserās sweep.
R Manual Bottom [0ā¦100]
Sets the lower limit of the right-channel phaserās sweep.
R Manual Top [0ā¦100]
Sets the upper limit of the right-channel phaserās sweep.
CONTROL
Sweep Mode [EG, Dmod]
Determines whether the phaser is controlled by the envelope
generator or by the modulation source. For more
information, see āSweep Modeā on page 807.
Source [Offā¦Tempo]
Selects the modulation source that triggers the EG (when EG
is selected for Sweep Mode), or modulation source that
causes the phaser to sweep (when Dmod is selected for
Sweep Mode). For more information, see āSourceā on
page 807.
EG
Attack [1ā¦100]
Sets the EG attack time. For more information Attack and
Release, see the graphic under āAttack [msec]ā on page 764.
Decay [1ā¦100]
Sets the EG decay time.
PHASER
Resonance [+/ā100]
This controls the intensity of the phaser. For more
information, see āResonanceā on page 808.
High Damp [%] [0ā¦100]
This sets the amount of high-frequency attenuation in the
phaserās feedback loop. Increasing the value will cut high-
range harmonics.
OUTPUT
Wet/Dry [āWetā¦
ā1:99,
Dry, 1: 99ā¦Wet]
Sets the balance between the āwetā processed sound and the
dry input. Negative values invert the phase of the wet signal.
This interacts with Resonance; for more information, see
āResonanceā on page 808.
Source [Offā¦Tempo]
Selects a modulation source for Wet/Dry.
Amount [+/ā100]
Sets the modulation amount for Wet/Dry.
EG Attack/Decay
EG
D-mod
Sweep Mode
D
-mod
Phaser
Phaser
Left
Right
Resonance
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out