EXi PROGRAM > EP-1: Home 0–1: Overview
361
EXi PROGRAM > EP-1: Home
0–1: Overview
This is the main page of PROGRAM mode. For a full
description of this page and all of its functions, please see
“EXi PROGRAM > Home” on page 127. This section
describes only the overview display, which differs for each
individual EXi.
0–1b: Overview and Page Jump
This PROGRAM > Home page shows an overview of the
most important settings for the Program’s two EXi
instruments. The specific parameters will vary, depending on
which EXi are being used.
The graphics give you a quick way to check all of these
settings at a glance. They also let you jump instantly to any
of the displayed parameters. Just touch one of the graphics,
and you’ll jump to the page containing its parameters.
Tip: Pressing EXIT several times will always bring you back
to this page.
Model Type
This shows the selected Model Type—Tine EP1, Reed EP
200A, etc.—which controls the basic sound of the EP-1.
Touch this area to jump to the EP-1’s Basic/Oscillator page.
For more information, see “EXi PROGRAM > EP-1:
Basic/Oscillator” on page 362.
Panel/IFX
This section shows the EP’s front panel settings, the selected
effect, and the cabinet (if enabled). Touch this area to jump
to the EP-1’s Panel/IFX/Amp & Cabinet page. For more
information, see “EXi PROGRAM > EP-1: Panel/IFX/Amp”
on page 366.
Common Key Zone
This shows the key zones for EXi1 and EXi2, as set on the
Common section’s Program Basic page, in relation to the
entire MIDI note range. The range of the 61-, 73-, or 88-note
keyboard is also shown, as appropriate.
Press this area to jump to the PROGRAM (Common) >
Basic/X-Y– Program Basic page.
0–1d: Common
3Band EQ Graphic
Mute (1) [On, Off]
Mute (2) [On, Off]
Mute (DrumT) [On, Off]
EXi1 Instrument Volume [000…127]
EXi2 Instrument Volume [000…127]
Drum Track Volume [000…127]
This is the same as with HD-1 programs. For more
information, please see “0–1d: Common” on page 4.
v
0–1: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Show MS/WS/DKit Graphics →p.113
• Add To Set List →p.113
• Initialize Program →p.113
•PAGE →p.126
•MODE →p.126
0–1b
Common
Key Zone
0–1d
0–1PMC
To Next Page
Loading...
Need help?
General
