COMBINATION > MFX/TFX 9–2: MFX1
431
9–2: MFX1
Here you can edit the parameters of the master effect 1.
Effects Modulation: Dmod
Most effects have one or more parameters which can be
modulated in realtime. In the NAUTILUS, this is called
Dynamic Modulation, or Dmod for short.
For a complete list of Dmod sources, see “Dynamic
Modulation Source List” on page 910.
You can use different MIDI channels to control Dmod for
each effect, if desired, as selected by the Ch (Control
Channel) parameter.
9–2a: MFX1
MFX1 On/Off [Off, On]
This turns master effect 1 on/off. This is linked with the
on/off setting in the MFX/TFX– Routing page.
Ch (Control Channel) [Ch01…16, G ch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master effect.
Ch01…Ch16: The specified MIDI channel will be used for
control.
G ch: The global MIDI Channel (GLOBAL 1–1a) will be
used for control. Normally you will use the G ch setting.
P (Effect Preset) [P00, P01…15, U00…15, --------]
Effect Presets let you easily store and recall all of the
settings for an individual effect. You can store up to 16 user
presets for each effect type, in addition to 15 re-writable
factory presets.
The same presets appear in all of the modes (PROGRAM,
COMBINATION, SEQUENCE, and SAMPLING), and sets
of presets can be saved to and loaded from drive.
Note that edits to effects parameters are automatically stored
with the Combination–you don’t need to store them as an
Effect Preset. Presets just make it easier to re-use your
favorite settings.
For instance, you can save an Effect Preset while working on
a particular Combination, and then later use the same Effect
Preset in a different Program, Combination, or Song.
P00: Initial Set: These are the default settings that are
recalled when you select an effect type. You can’t save your
own settings here.
P01…P15: These usually contain Korg preset data (though
some effects may not include presets). We recommend that
you store your settings in U00–U15.
U00…U15: These are areas in which you can store your
own settings.
---------------: This shows that no Effect Preset has been
selected. You’ll see this if you’ve just selected an effect,
written a Combination, or selected a new Combination.
Selecting this setting from the menu will not have any effect.
Note: Combinations save the effects parameter settings, but
they don’t save the number of the selected Effect Preset. If
you select an Effect Preset, and then save the Combination,
the Effect Preset setting will revert to “--------------.”
For more information, please see “Effect preset function” on
page 103.
MFX1 Parameters
Here you can set the effect type parameters selected in the
master effect 1.
For details on the master effects, please see the “Effect
Guide” on page 729.
To Next Page
Loading...
Need help?
General
