Korg NAUTILUS Series - 041: Stereo Harmonic Chorus

800
041: Stereo Harmonic Chorus
This effect applies chorus only to higher frequencies. This
can be used to apply a chorus effect to a bass sound without
making the sound thinner. You can also use feedback to turn
the chorus into a flanger.
CHORUS
Pre Delay [msec] [0.0…50.0]
Sets the delay time from the original sound.
Depth [0…100]
Sets the depth of LFO modulation.
Source [Off…Tempo]
Selects the modulation source of the LFO modulation depth.
Amount [+/–100]
Sets the modulation amount of the LFO modulation depth.
Feedback [+/–100]
Sets the feedback amount for the chorus. Increasing the
feedback turns the chorus into a flanger.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation for the
chorus.
High/Low Split Point [1…100]
This sets the frequency split point between the low and high
ranges. Only the high range will be processed through the
chorus.
Low Level [0…100]
Sets the low range output level.
High Level [0…100]
Sets the high range (chorus) output level.
LFO
Waveform [Triangle, Sine]
Selects the LFO Waveform.
Phase [degrees] [–180…+180]
Sets the LFO phase difference between the left and right. See
“Phase [degrees]” on page 781.
Frequency [Hz] [0.02…20.00]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source [Off…Tempo]
This selects a modulation source for the Frequency.
Amount [–20.00…+20.00]
This sets the Frequency modulation amount, in Hz.
MIDI/Tempo Sync [Check-box]
BPM [MIDI, 40.00…300.00]
Base Note [ …  ]
Times [x1…x32]
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see “MIDI/Tempo Sync” on page 779.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual LFO, or
one of the Common FX LFOs. For more information, see
“LFO Type” on page 779.
Common LFO Phase Offset [degrees] [+/–180]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Left
Right
Feedback
LFO Phase
LFO: Tri / Sine
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
Low Level
Low Level
High Level
High Level
High/Low Split Point
High Damp
Chorus/Flanger
Chorus/Flanger