Korg NAUTILUS Series

SEQUENCER mode
518
SEQUENCER > MFX/TFX
Here you can make settings for the master effects and total
effects. For more information, please see “Effect Guide” on
page 729.
9–1: Routing
Here you can specify the type of master effects and total
effects, and turn them on/off. The meters below the effects
names display the effect output levels in realtime, showing
the combined peak signals of the left and right channels.
The master effects are sent to the L/R bus. The total effects
are inserted into the L/R bus.
These parameters are the same as in PROGRAM mode. For
more information, please see “9–1: Routing” on page 107.
9–1a: MFX1, 2
MFX1:
MFX1 [000…197]
MFX1 On/Off [Off, On]
Return 1 [000…127]
MFX2:
MFX2 [000…197]
MFX2 On/Off [Off, On]
Return 2 [000…127]
Chain:
Chain On/Off [Off, On]
Chain Direction [MFX1→MFX2, MFX2→MFX1]
Chain Level [000…127]
9–1b: TFX1, 2
TFX1:
TFX1 [000…197]
TFX1 On/Off [Off, On]
TFX2:
TFX2 [000…197]
TFX2 On/Off [Off, On]
9–1c: Master Volume
Master Volume [000…127]
v 9–1: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Copy MFX/TFX →p.125
• Swap MFX/TFX →p.125
• Put Effect Setting to Track →p.554
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
• PAGE →p.126
•MODE →p.126
9–1PMC
9–1a
9–1b
1–1a
9–1c