GLOBAL > Controllers/Scales 2–2: User Scales
657
2–2: User Scales
Here you can make settings for sixteen different User Octave
Scales and one User All Notes scale.
The user scales you create here can be selected from the
following pages.
• (HD-1) PROGRAM > Basic/X-Y/Controllers– Program
Basic
• (EXi Common) PROGRAM > Basic/X-Y/Controllers–
Program Basic
• COMBINATION > Timbre Parameters– Pitch
• SEQUENCER > Track Parameters– Pitch
If you wish to keep an edited user scale after the power is
turned off, be sure to write (save) your settings.
Use the page menu command Write Global Setting to
open the dialog box, and write the data.
2–2a: User Octave Scale
User Octave Scale [User Octave Scale 00…15]
Selects the User Octave Scale that you want to edit.
Tune [–99…+99]
Makes pitch settings for each note in the octave.
When you adjust the pitch of each note in the octave (C–B)
in one-cent steps, your settings will be applied to all octaves.
This adjustment is relative to equal temperament.
A setting of –99 lowers the pitch approximately a semitone
below normal pitch.
A setting of +99 raises the pitch approximately a semitone
above normal pitch.
The note can also be selected by holding down the ENTER
button and playing a note on the keyboard.
By executing the page menu command “Copy Scale,” you
can copy settings from a preset scale (other than Stretch) or
from another user scale.
2–2b: User All Notes Scale
Tune [–99…+99]
Makes independent pitch settings for each of the 128 notes.
Adjust the pitch of each of the 128 notes (C–1 – G9) in one-
cent steps. This adjustment is relative to equal temperament.
A setting of –99 lowers the pitch approximately a semitone
below normal pitch.
A setting of +99 raises the pitch approximately a semitone
above normal pitch.
Use the horizontal scroll bar to move to the key range that
you want to set, and select the key that you want to specify.
The note can also be selected by holding down the ENTER
button and playing a note on the keyboard.
By executing the page menu command “Copy Scale,” you
can copy settings from a preset scale (including Stretch) or
another user scale.
v
2–2: Page Menu Commands
• Write Global Setting →p.684
• Copy Scale →p.690
•PAGE →p.126
•MODE →p.126
To Next Page
Loading...
Need help?
General
