Korg NAUTILUS Series

GLOBAL mode
690
• When receiving an All Programs data dump, only bank
data whose bank type matches will be received. If banks
of a different bank type are received, the message
“Program Bank Type Conflicts” will be displayed.
Reset Controller MIDI Assign
This automatically sets the MIDI CC# Assign– Controllers
on the Controllers/Scales– Controllers page.
5. Choose “Reset Controller MIDI Assign” to open the
dialog box.
6. Set the “To” field to the desired reset method.
All Off: All settings will be Off.
Default Setting: The ARP/DRUM controls and pads will
all be set to Off; the X-Y Control will be set to its default
CCs.
CC Default: This sets up the recommended CCs for the
pads and ARP/DRUM controls, as well as the X-Y
Control. The default values are shown in the table below.
If you want to record ARP/DRUM controllers in
SEQUENCER mode, or use the controllers with external
MIDI devices, we recommend using this setting.
(You are also free to assign different MIDI CCs to the
controllers, if you wish.)
7. Press the OK button to execute the reset command, or
press the Cancel button to cancel.
Reset Controller MIDI Assign Default
Copy Scale
This command copies data from a preset scale or between
user scales. For details on the preset scales, see “1–1e:
Scale” on page 38.
1. Select “Copy Scale” to open the dialog box.
2. Use “From” to select the copy-source scale.
If you select Pure Major or Pure Minor, specify the “Key”
(located at the right) as well.
Stretch cannot be selected if “To” is User All Notes Scale.
3. In “To,” selects the copy destination scale.
4. To execute the Copy Scale command, press the OK
button. To cancel, press the Cancel button.
Clear Special Function Assignments
This command appears on the Function Assign page. It
resets all of the assignments to the default values: MIDI
Channel = Gch, and CC = Off.
Write Wave Sequence
A dialog box for saving a wave sequence will appear. You
can select a new location, and edit the name of the wave
sequence.
You must write an edited wave sequence if you want to keep
it. An edited wave sequence cannot be recovered if you turn
off the power or select a different wave sequence before
writing it.
1. Choose “Write Wave Sequence” to open the dialog
box.
2. The upper line shows the Wave Sequence name. To
edit the name, press the text edit button to open the
text edit dialog box, and set the name as desired (up to
24 characters).
If a USB QWERTY keyboard (commercially available) is
connected, you can use this to enter text instead of the on-
screen keyboard. For more information, see “Editing
names and entering text” on page 202 of the OG.
3. Use the lower line “To Wave Sequence” to select the
writing-destination.
You can also press the popup button and choose the
writing-destination from the “Wave Sequence Select”
menu. If you select the “Wave Sequence Select” menu,
Default
Setting
CC
Default
ARP/DRUM LATCH Off (CC#31)
ARP Off (CC#14)
DRUM Off (CC#15)
GATE Off (CC#22)
VELOCITY Off (CC#23)
LENGTH Off (CC#24)
SWING Off (CC#25)
DRUM SD Off (CC#26)
X-Y Control XY X (CC#118) (CC#118)
XY Y (CC#119) (CC#119)