Korg NAUTILUS Series

SEQUENCER > EQ/X-Y/Controllers 1–1: MIDI Track EQ
467
Input Trim [00…99]
This controls the volume level going into the EQ. Note that
this parameter uses a linear scale; 50 is equivalent to –6dB,
25 is the same as –12dB, and so on.
High settings of the Low, Mid, and High Gain controls can
cause substantial increases in the overall level. You can
compensate for this by turning down the input trim.
The meter to the left of the parameter shows the post-EQ
signal level in realtime.
High Gain [–18.0…+18.0dB]
This controls the gain of the 10kHz High Shelf EQ, in
increments of 0.5dB.
Mid Frequency [100Hz…10.00kHz]
This sets the center frequency for the Mid sweep EQ.
Mid Gain [–18.0…+18.0dB]
This controls the gain of the Mid Sweep EQ, in increments
of 0.5dB.
Low Gain [–18.0…+18.0dB]
This controls the gain of the 80Hz Low Shelf EQ, in
increments of 0.5dB.
Track 02…16 (Track Number)
These parameters adjust the three-band EQ (with sweepable
mid range) for MIDI tracks 2 through 16. They are the same
as for track 1. See “Track 01”:.
v 1–1: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Rename Song →p.521
• Initialize Song →p.522
• Copy From Song →p.522
• Load Template Song →p.522
• Save Template Song →p.523
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
• GM Initialize →p.523
• Copy from Combi →p.525
• Copy From Program →p.525
• Show EQ Graphic →p.436
• Stereo Pair →p.525
• PAGE →p.126
• MODE →p.126