Korg NAUTILUS Series Parameter Guide

EXi: MOD-7 Waveshaping VPM Synthesizer
346
MOD-7 Tone Adjust parameters
In addition to the Common Tone Adjust parameters listed
above, the MOD-7 adds a number of its own parameters.
Note that these additional parameters are separate for each
EXi, as opposed to being shared by both EXi in the Program.
All of the additional parameters are listed below. Tone
Adjust parameters may affect the internal parameters in one
of two ways: they may be Relative, in which case they scale
the existing parameter value, or Absolute, in which case
they over-write the existing value. Unless otherwise noted,
all of the MOD-7 parameters are Absolute.
Macro Parameters
Brightness
Brightness Vel Sens
Timbre
Feedback
Detune
Noise
Saturation
Filter Freq
PCM Oscillator
On/off
MS Select
MS Bank
MS Min
MS Max
Start Offset
Reverse
Transpose
Tune
VPM Oscillators 1…6
On/off
Mode
Feedback
Ratio
Table
Drive
Output Level
Filters A and B
Type
Cutoff
Resonance
EG Int
LFO Int
LFOs
In addition to supporting the standard Tone Adjust LFO
parameters, the MOD-7 adds the following separate
controls:
• LFO 1 through 4 Waveform
• LFO 3 and 4 Speed
Step Sequencer
Attack Smoothing
Decay Smoothing

Korg NAUTILUS Series Specifications

General

Sampling	Open Sampling System
MIDI	In, Out, Thru
Preset Combinations	384
Keyboard	61-key (NAUTILUS 61), 73-key (NAUTILUS 73), 88-key (NAUTILUS 88, RH3 weighted action)
Effects	12 Insert Effects; 2 Master Effects; 2 Total Effects
Sequencer	16-track MIDI Sequencer
Storage	Internal SSD (60 GB)
Audio Inputs	2 x 1/4"
Audio Outputs	Headphones
USB	Type A (host), Type B (device)
Weight	NAUTILUS 88: 23.1 kg
Display	8 inch TouchView™ GUI (800x600 pixels)