PROGRAM mode: HD-1
116
Select Directory/File for Sample To Disk
4. Press the Stop button once again to stop playback.
If the WAVE file is mono, the same sound will be output to
L/R.
Auto Sampling Setup
Auto Sampling Setup is available on the Audio
In/Sampling tab of the Play page.
This command automatically configures the PROGRAM
mode sampling-related parameters, making it easy for you to
sample an external audio source or to resample your
performance as you play a Program. You can also use this
command to initialize the sampling settings.
After using Auto Sampling Setup, you can further adjust
any of the settings to suit your needs as described in the
“Note” paragraphs of each section.
When you execute this command, the applicable
parameters will be set automatically. You cannot use the
page menu command “Compare” to recall the previous
settings.
1. Select Auto Sampling Setup to open the dialog box.
2. Press a radio button to select the type of settings you
want to make.
Initialize: Initializes the sampling-related parameters to
their default state.
Resample Program Play: Sets the sampling-related
parameters to allow you to play a Program and resample
your performance.
REC Audio Input: Sets the sampling-related parameters so
that you can sample an external audio source. With these
settings, you can play a Program while sampling, but only
the external input will be recorded.
3. These settings will depend on the choice you make in
step 2.
Initialize
If you selected Initialize:
Press the OK button to execute the Initialize operation, or
press the Cancel button if you decide not to execute. For
more information, see “Automatically-set parameters and
their values” on page 118.
Resample Program Play
If you selected Resample Program Play:
1. Use “Save to” to select either RAM or DISK as the
destination to which the resampled data will be
written.
If you choose RAM, the sampled data will be written into
RAM for use in SAMPLING mode. If you choose DISK, the
sampled data will be saved to drive as a WAVE file.
2. If Save to is set to RAM, you can also specify whether
the sample will be automatically converted to a
To Next Page
Loading...
Need help?
General
