Cleaning and Maintenance 7-11
21. Unplug the Imaging Unit CRUM connector (P/J484) at the top of the Developer
Frame Assembly.
22. Release the hooks to disconnect the 4 toner nozzles attached to the Developer
Frame Assembly.
Note
Check that the toner nozzle shutter is closed. If the shutter is open; close it
immediately.
23. Holding the handle of the Developer Frame Assembly, remove it upward.
Note
Toner will spill from openings in the Developer Assemblies. Prepare a location to
replace the Developer Assemblies by covering a flat surface with paper or other
material to capture Toner spilled during the replacement procedure.
s6300-196
Note
P/J484
Developer Frame
Assembly
To Next Page
Loading...
