EasyManua.ls Logo

Dell Force10 MXL Blade - Page 160

Dell Force10 MXL Blade
732 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
160 | Data Center Bridging
www.dell.com | support.dell.com
To remove an ETS output policy from an interface, enter the no dcb-policy output policy-name
command. ETS is enabled by default with the default ETS configuration applied (all dot1p priorities in
the same group with equal bandwidth allocation).
Related
Commands
dcb-policy output stack-unit stack-ports all
Apply the specified DCB output policy on all ports of the switch stack or a single stacked switch.
Syntax
dcb-policy output stack-unit {all | stack-unit-id} stack-ports all dcb-output-policy-name
To remove all DCB input policies applied to the stacked ports, use the no dcb-policy output stack-unit
all
command.
To remove only the DCB input policies applied to the specified switch, use the no dcb-policy output
stack-unit
command.
Parameters
Defaults
none
Command Modes
CONFIGURATION
Command
History
Usage
Information
The dcb-policy output stack-unit all command overwrites any previous dcb-policy output stack-unit
stack-unit-id
configurations. Similarly, a dcb-policy output stack-unit stack-unit-id command
overwrites any previous dcb-policy output stack-unit all configuration.
You can apply a DCB output policy with ETS configuration to all stacked ports in a switch stack or an
individual stacked switch. You can apply different DCB output policies to different stack units.
Related
Commands
dcb stack-unit all pfc-buffering pfc-port-count pfc-queues
Configure the PFC buffer for all switches in the stack.
Syntax
dcb stack-unit all pfc-buffering pfc-port-count {1-56} pfc-queues {1-2}
To remove the configuration for the PFC buffer on all switches in the stack, use the no dcb stack-unit
all pfc-buffering pfc-port-count pfc-queues
command.
dcb-output Create a DCB output policy.
stack-unit-id
Enter the stack unit identification.
dcb-output-policy-
name
Enter the policy name for the DCB output policy.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
dcb-policy input stack-unit
stack-ports all
Apply the specified DCB input policy.

Table of Contents

Other manuals for Dell Force10 MXL Blade

Related product manuals