Dell Force10 MXL Blade - Page 164

164 | Data Center Bridging
www.dell.com | support.dell.com
Command
History
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
Defaults
none
Command Modes
DCB INPUT POLICY
DCB OUTPUT POLICY
Command
History
Related
Commands
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
Syntax
ets mode on
To remove the ETS configuration, use the ets mode on command.
Defaults
ETS mode is on.
Command Modes
DCB OUTPUT POLICY
Command
History
Usage
Information
If you disable ETS in an output policy applied to an interface using the no ets mode on command, any
previously configured QoS settings at the interface or global level take effect. If QoS settings are
configured at the interface or global level and in an output policy map (service-policy output
command), the QoS configuration in the output policy takes precedence.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
text
Enter the description of the output policy.
Maximum: 32 characters.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
dcb-input Create a DCB PFC input policy.
dcb-policy input Apply the output policy.
dcb-output Create a DCBETS output policy.
dcb-policy output Apply the output policy.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module