Dell Force10 MXL Blade - Page 165

Data Center Bridging | 165
Related
Commands
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
Defaults
0x8
Usage
Information
This command is available at the global level only.
Command Modes
PROTOCOL LLDP
Command
History
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits command.
Parameters
Defaults
0x10
Usage
Information
This command is available at the global level only.
Command Modes
PROTOCOL LLDP
Command
History
dcb-output Create a DCB output policy.
dcb-policy output Apply the output policy.
priority-bitmap
Enter the priority-bitmap range.
The valid range is 1 to FF.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
priority-bitmap
Enter the priority bitmap.
The valid range is 1 to FF.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module