Dell Force10 MXL Blade - Page 183

Data Center Bridging | 183
show qos dcb-output
Displays the ETS configuration in a DCB output policy.
Syntax
show qos dcb-output [ets-profile]
Parameters
Command Mode
EXEC PRIVILEGE
Command
History
Example
Figure 9-7. show qos dcb-output Command Example
show qos priority-groups
Displays the ETS priority groups configured on the switch, including the 802.1p priority classes and ID
of each group.
Syntax
show qos priority-groups
Command Mode
EXEC PRIVILEGE
Command
History
Example
Figure 9-8. show qos priority-groups Command Example
show stack-unit stack-ports ets detail
Displays the ETS configuration applied to egress traffic on stacked ports, including ETS operational
mode on each unit and the configurated priority groups with dot1p priorities, bandwidth allocation, and
scheduler type.
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-number} ets detail
[ets-profile] Enter the ETS profile.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS# show qos dcb-output
dcb-output ets
priority-group san qos-policy san
priority-group ipc qos-policy ipc
priority-group lan qos-policy lan
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Force10#Force10#show qos priority-groups
priority-group ipc
priority-list 4
set-pgid 2