Dell Force10 MXL Blade - Page 185

Data Center Bridging | 185
show stack-unit stack-ports pfc detail
Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC operational
mode on each unit with the configured priorities, link delay, and number of pause packets sent and
received.
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-number} pfc detail
Parameters
Command Mode
CONFIGURATION
Command
History
Example
Figure 9-10. show stack-unit all stack-ports all pfc details Command Example
stack-unit
Enter the stack unit.
port-number
Enter the port number.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)# show stack-unit all stack-ports all pfc details
stack unit 0 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
stack unit 1 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts