Dell Force10 MXL Blade - Page 391

Open Shortest Path First (OSPFv2) | 391
Command
History
Example
Figure 21-1. debug ip ospf process-id packet Command Example
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Table 21-1. debug ip ospf process-id packet Output Descriptions
Field Description
8:14 Displays the time stamp.
OSPF Displays the OSPF process ID: instance ID.
v: Displays the OSPF version. FTOS supports version 2 only.
t: Displays the type of packet sent:
• 1 - Hello packet
• 2 - database description
• 3 - link state request
• 4 - link state update
• 5 - link state acknowledgement
l: Displays the packet length.
rid: Displays the OSPF router ID.
aid: Displays the Autonomous System ID.
chk: Displays the OSPF checksum.
aut: States if OSPF authentication is configured. One of the following is listed:
• 0 - no authentication configured
• 1 - simple authentication configured using the ip ospf authentication-key command)
• 2 - MD5 authentication configured using the ip ospf message-digest-key command.
auk: If the ip ospf authentication-key command is configured, this field displays the key used.
keyid: If the ip ospf message-digest-key command is configured, this field displays the MD5 key
to: Displays the interface to which the packet is intended.
dst: Displays the destination IP address.
netmask: Displays the destination IP address mask.
pri: Displays the OSPF priority
FTOS#debug ip ospf 1 packet
OSPF process 1, packet debugging is on
FTOS#
08:14:24 : OSPF(100:00):
Xmt. v:2 t:1(HELLO) l:44 rid:192.1.1.1
aid:0.0.0.1 chk:0xa098 aut:0 auk: keyid:0 to:TenGig 4/3 dst:224.0.0.5
netmask:255.255.255.0 pri:1 N-, MC-, E+, T-,
hi:10 di:40 dr:90.1.1.1 bdr:0.0.0.0