Dell Force10 MXL Blade - Page 392

392 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
default-information originate
Configure the FTOS to generate a default external route into an OSPF routing domain.
Syntax
default-information originate [always] [metric metric-value] [metric-type type-value]
[route-map map-name]
To return to the default values, use the no default-information originate command.
Parameters
Defaults
Disabled.
Command Modes
ROUTER OSPF
Command
History
Related
Commands
N, MC, E, T Displays information available in the Options field of the HELLO packet:
• N + (N-bit is set)
• N - (N-bit is not set)
• MC+ (bit used by MOSPF is set and router is able to forward IP multicast packets)
• MC- (bit used by MOSPF is not set and router cannot forward IP multicast packets)
• E + (router is able to accept AS External LSAs)
• E - (router cannot accept AS External LSAs)
• T + (router can support TOS)
• T - (router cannot support TOS)
hi: Displays the amount of time configured for the HELLO interval.
di: Displays the amount of time configured for the DEAD interval.
dr: Displays the IP address of the designated router.
bdr: Displays the IP address of the Border Area Router.
Table 21-1. debug ip ospf process-id packet Output Descriptions
Field Description
always (OPTIONAL) Enter the keyword always to specify that default route
information must always be advertised.
metric metric-value
(OPTIONAL) Enter the keyword metric followed by a number to configure a
metric value for the route.
Range: 1 to 16777214
metric-type type-value (OPTIONAL) Enter the keyword metric-type followed by an OSPF link
state type of 1 or 2 for default routes. The values are:
• 1 = Type 1 external route
• 2 = Type 2 external route.
route-map map-name (OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
redistribute Redistributes routes from other routing protocols into OSPF.