Dell Force10 MXL Blade - Page 44

44 | Control and Monitoring
www.dell.com | support.dell.com
Example
Figure 4-4. do Command Example
enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you
may need to enter a password.
Syntax
enable [level]
Parameters
Defaults
15
Command Modes
EXEC
Command
History
Usage
Information
Users entering EXEC Privilege mode or any other configured privilege level can access configuration
commands. To protect against unauthorized access, use the enable password command to configure a
password for the enable command at a specific privilege level. If no privilege level is specified, the
default is privilege level 15.
Related
Commands
enable optic-info-update interval
Enable polling intervals of optical information updates for SNMP.
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-update interval
command.
Parameters
Defaults
Disabled
FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
level
(OPTIONAL) Enter a number for a privilege level of FTOS.
Range: 0 to 15.
Default: 15
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
enable password
Configures a password for the
enable command and to access a privilege level.
interval seconds
Enter the keyword interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)