Dell Force10 MXL Blade - Page 45

Control and Monitoring | 45
Command Modes
CONFIGURATION
Command
History
Usage
Information
The default interval for the polling is 300 seconds (5 minutes). Use this command to enable the polling
and to configure the polling frequency.
end
Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION or
ROUTER OSPF modes).
Syntax
end
Command Modes
• CONFIGURATION
• SPANNING TREE
• MULTIPLE SPANNING TREE
• LINE
• INTERFACE
• VRRP
• ACCESS-LIST
• PREFIX-LIST
• ROUTER OSPF
• ROUTER RIP
Command
History
Related
Commands
exec-banner
Enable the display of a text string when the user enters EXEC mode.
Syntax
exec-banner
Defaults
Enabled on all lines (if configured, the banner appears).
Command Modes
LINE
Command
History
Usage
Optionally, use the banner exec command to create a text string that is displayed when the user
accesses EXEC mode. This command toggles that display.
Related
Commands
Version 8.3.16.1
Replaces the
enable xfp-power-updates command.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
exit Returns to the lower command mode.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
banner exec Configures a banner to display when entering EXEC mode.
line Enables and configures console and virtual terminal lines to the system.