Dell Force10 MXL Blade - Page 46

46 | Control and Monitoring
www.dell.com | support.dell.com
exec-timeout
Set a time interval for the system to wait for input on a line before disconnecting the session.
Syntax
exec-timeout minutes [seconds]
To return to default settings, enter no exec-timeout.
Parameters
Defaults
10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes
LINE
Command
History
Usage
Information
To remove the time interval, use the exec-timeout 0 0 command.
Example
Figure 4-5. FTOS time-out display
exit
Return to the lower command mode.
Syntax
exit
Command Modes
• EXEC Privilege
• CONFIGURATION
• LINE
• INTERFACE
• PROTOCOL GVRP
• SPANNING TREE
• MULTIPLE SPANNING TREE
• MAC ACCESS LIST
• ACCESS-LIST
• PREFIX-LIST
• ROUTER OSPF
• ROUTER RIP
minutes
Enter the number of minutes of inactivity on the system before disconnecting the current
session.
Range: 0 to 35791
Default: 10 minutes for console line; 30 minutes for VTY line.
seconds
(OPTIONAL) Enter the number of seconds
Range: 0 to 2147483
Default: 0 seconds
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS con0 is now available
Press RETURN to get started.
FTOS>