Dell Force10 MXL Blade - Page 493

Routing Information Protocol (RIP) | 493
Parameters
Command Modes
EXEC Privilege
Command
History
default-information originate
Generate a default route for the RIP traffic.
Syntax
default-information originate [always] [metric metric-value] [route-map map-name]
To return to the default values, use the no default-information originate command.
Parameters
Defaults
Disabled
metric: 1
Command Modes
ROUTER RIP
Command
History
Usage
Information
The default route must be present in the switch routing table for the default-information originate
command to take effect.
interface
(OPTIONAL) Enter the interface type and ID as one of the following:
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
database (OPTIONAL) Enter the keyword database to display messages when there is a change to
the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol changes.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
always (OPTIONAL) Enter the keyword always to enable the switch software to
always advertise the default route.
metric metric-value (OPTIONAL) Enter the keyword metric followed by a number as the
metric value.
Range: 1 to 16
Default: 1
route-map map-name (OPTIONAL) Enter the keyword route-map followed by the name of a
configured route-map.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module