Dell Force10 MXL Blade - Page 494

494 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
default-metric
Change the default metric for routes. Use this command with the redistribute command to ensure
that all redistributed routes use the same metric value.
Syntax
default-metric number
To return the default metric to the original values, use the no default-metric command.
Parameters
Default
1
Command Modes
ROUTER RIP
Command
History
Usage
Information
This command ensures that route information being redistributed is converted to the same metric value.
Related
Commands
description
Enter a description of the RIP routing protocol
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
none
Command Modes
ROUTER RIP
Command
History
Related
Commands
number
Specify a number.
Range: 1 to 16.
The default is 1.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
redistribute Allows you to redistribute routes learned by other methods.
description
Enter a description to identify the RIP protocol (80 characters maximum).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
router rip Enters ROUTER mode on the switch.