Uplink Failure Detection (UFD) | 653
You can assign individual member ports of a port channel to the group. An uplink-state group can
contain either the member ports of a port channel or the port channel itself, but not both.
Related
Commands
Example
Figure 36-5. upstream Command Example
downstream Assigns a port or port-channel to the uplink-state group as a downstream
interface.
upstream Assigns a port or port-channel to the uplink-state group as an upstream interface.
uplink-state-group Creates an uplink-state group and enable the tracking of upstream links.
FTOS(conf-uplink-state-group-16)# upstream tengigabitethernet 1/10-15
FTOS(conf-uplink-state-group-16)#
To Next Page
Loading...
