Dell Force10 MXL Blade - Page 685

Debugging and Diagnostics | 685
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
Figure 39-3. show hardware stack-unit phy-firmware-version Command Example
drops [unit 0-0 [port
1-56]]
Enter the drops keyword to display internal drops on the selected stack
member. Optionally, use the
unit keyword with 0 to select port-pipe 0, and
then use
port 1-56 to select a port on that port-pipe.
stack-port 33-56
Enter this keyword and a stacking port number to select a stacking port for
which to display statistics. Identify the stack port number as you would to
identify a 10G port that was in the same place in one of the rear modules.
Note: You can identify stack port numbers by physical inspection of
the rear modules. The numbering is the same as for the 10G ports.
You can also inspect the output of the
show system stack-ports
command.
unit 0-0 {counters | details
| port-stats
[detail] |
register
}
Enter the unit keyword followed by 0 for port-pipe 0, and then enter one of
the following keywords to troubleshoot errors on the selected port-pipe and
to give status on why a port is not coming up to register level:
counters,
details, port-stats [detail], or register
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show hardware stack-unit 0 phy-firmware-version
PortNumber Status Programmed Version SW Version
=======================================================================
41 Present 01.06
01.06
42 Present 01.06
01.06
43 Present 01.06
01.06
44 Present 01.06
01.06
45 Present 01.06
01.06
46 Present 01.06
01.06
47 Present 01.06
01.06
48 Present 01.06
01.06
49 Not Present N/A
N/A
FTOS#