C
HAPTER
37
| Class of Service Commands
Priority Commands (Layer 3 and 4)
– 1179 –
show qos map
cos-dscp
This command shows ingress CoS/CFI to internal DSCP map.
SYNTAX
show qos map cos-dscp interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show qos map cos-dscp interface ethernet 1/5
CoS Information of Eth 1/5
CoS-DSCP map.(x,y),x: PHB,y: drop precedence:
CoS : CFI 0 1
---------------------------------
0 (0,0) (0,0)
1 (1,0) (1,0)
2 (2,0) (2,0)
3 (3,0) (3,0)
4 (4,0) (4,0)
5 (5,0) (5,0)
6 (6,0) (6,0)
7 (7,0) (7,0)
Console#
show qos map
dscp-mutation
This command shows the ingress DSCP to internal DSCP map.
SYNTAX
show qos map dscp-mutation interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
COMMAND MODE
Privileged Exec
COMMAND USAGE
This map is only used when the QoS mapping mode is set to “DSCP” by the
qos map trust-mode command, and the ingress packet type is IPv4.
EXAMPLE
The ingress DSCP is composed of “d1” (most significant digit in the left
column) and “d2” (least significant digit in the top row (in other words,
To Next Page
Loading...
Need help?
General
