C
HAPTER
45
| IP Interface Commands
IPv6 Interface
– 1416 –
This example displays a brief summary of IPv6 addresses configured on the
switch.
Console#show ipv6 interface brief
Interface VLAN IPv6 IPv6 Address
--------------- ---------- ---------- ------------------------------------
VLAN 1 Up Up 2001:DB8:2222:7273::72/96
VLAN 1 Up Up FE80::2E0:CFF:FE00:FD%1/64
Console#
RELATED COMMANDS
show ip interface (1399)
show ipv6 mtu This command displays the maximum transmission unit (MTU) cache for
destinations that have returned an ICMP packet-too-big message along
with an acceptable MTU to this switch.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
The following example shows the MTU cache for this device:
Console#show ipv6 mtu
MTU Since Destination Address
1400 00:04:21 5000:1::3
1280 00:04:50 FE80::203:A0FF:FED6:141D
Console#
ND retransmit
interval
The interval between IPv6 neighbor solicitation retransmissions sent on an
interface during duplicate address detection.
ND advertised
retransmit
interval
The retransmit interval is included in all router advertisements sent out of
an interface so that nodes on the same link use the same time value.
ND reachable
time
The amount of time a remote IPv6 node is considered reachable after a
reachability confirmation event has occurred
ND advertised
reachable time
The reachable time is included in all router advertisements sent out of an
interface so that nodes on the same link use the same time value.
Table 198: show ipv6 interface - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General
