C
HAPTER
24
| Authentication Commands
AAA
– 825 –
group - Specifies the server group to use.
tacacs+ - Specifies all TACACS+ hosts configure with the
tacacs-server host command.
server-group - Specifies the name of a server group configured
with the aaa group server command. (Range: 1-64 characters)
DEFAULT SETTING
Accounting is not enabled
No servers are specified
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ The accounting of Exec mode commands is only supported by TACACS+
servers.
◆ Note that the default and method-name fields are only used to
describe the accounting method(s) configured on the specified
TACACS+ server, and do not actually send any information to the
server about the methods to use.
EXAMPLE
Console(config)#aaa accounting commands 15 default start-stop group tacacs+
Console(config)#
aaa accounting
dot1x
This command enables the accounting of requested 802.1X services for
network access. Use the no form to disable the accounting service.
SYNTAX
aaa accounting dot1x {default | method-name}
start-stop group {radius | tacacs+ |server-group}
no aaa accounting dot1x {default | method-name}
default - Specifies the default accounting method for service
requests.
method-name - Specifies an accounting method for service
requests. (Range: 1-64 characters)
start-stop - Records accounting from starting point and stopping
point.
To Next Page
Loading...
