C
HAPTER
20
| System Management Commands
File Management
– 726 –
stored on the TFTP server must be es3528mv2.bix. If the switch
detects a code version newer than the one currently in use, it will
download the new image. If two code images are already stored in
the switch, the image not set to start up the system will be
overwritten by the new version.
2. After the image has been downloaded, the switch will send a trap
message to log whether or not the upgrade operation was
successful.
3. It sets the new version as the startup image.
4. It then restarts the system to start using the new image.
â—† Any changes made to the default setting can be displayed with the
show running-config or show startup-config commands.
EXAMPLE
Console(config)#upgrade opcode auto
Console(config)#upgrade opcode path tftp://192.168.0.1/sm24/
Console(config)#
If a new image is found at the specified location, the following type of
messages will be displayed during bootup.
.
.
.
Automatic Upgrade is looking for a new image
New image detected: current version 1.1.1.0; new version 1.1.1.2
Image upgrade in progress
The switch will restart after upgrade succeeds
Downloading new image
Flash programming started
Flash programming completed
The switch will now restart
.
.
.
upgrade opcode
path
This command specifies an TFTP server and directory in which the new
opcode is stored. Use the no form of this command to clear the current
setting.
SYNTAX
upgrade opcode path opcode-dir-url
no upgrade opcode path
opcode-dir-url - The location of the new code.
DEFAULT SETTING
None
To Next Page
Loading...
Need help?
General
