C
HAPTER
4
| Basic Management Tasks
Setting the System Clock
– 134 –
Figure 14: Configuring NTP
CONFIGURING
TIME SERVERS
Use the System > Time (Configure Time Server) pages to specify the IP
address for NTP/SNTP time servers, or to set the authentication key for
NTP time servers.
SPECIFYING SNTP TIME SERVERS
Use the System > Time (Configure Time Server – Configure SNTP Server)
page to specify the IP address for up to three SNTP time servers.
CLI REFERENCES
â—† "sntp server" on page 752
PARAMETERS
The following parameters are displayed:
◆ SNTP Server IP Address – Sets the IPv4 or IPv6 address for up to
three time servers. The switch attempts to update the time from the
first server, if this fails it attempts an update from the next server in the
sequence.
WEB INTERFACE
To set the SNTP time servers:
1. Click System, then Time.
2. Select Configure Time Server from the Step list.
3. Select Configure SNTP Server from the Action list.
4. Enter the IP address of up to three time servers.
5. Click Apply.
To Next Page
Loading...
Need help?
General
