C
HAPTER
41
| CFM Commands
Cross Check Operations
– 1347 –
EXAMPLE
This example defines a static MEP for the specified maintenance
association.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name rd vlan 1
Console(config-ether-cfm)#mep crosscheck mpid 2 ma rd
Console(config-ether-cfm)#
ethernet cfm mep
crosscheck
This command enables cross-checking between the static list of MEPs
assigned to other devices within the same maintenance association and the
MEPs learned through continuity check messages (CCMs). Use the disable
keyword to stop the cross-check process.
SYNTAX
ethernet cfm mep crosscheck {enable | disable}
md domain-name ma ma-name
enable – Starts the cross-check process.
disable – Stops the cross-check process.
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – MA name. (Range: 1-43 alphanumeric characters)
DEFAULT SETTING
Disabled
COMMAND MODE
Privileged Exec
COMMAND USAGE
â—† Before using this command to start the cross-check process, first
configure the remote MEPs that exist on other devices inside the
maintenance association using the mep crosscheck mpid command.
These remote MEPs are used in the cross-check operation to verify that
all endpoints in the specified MA are operational.
â—† The cross-check process is disabled by default, and must be manually
started using this command with the enable keyword.
EXAMPLE
This example enables cross-checking within the specified maintenance
association.
Console#ethernet cfm mep crosscheck enable md voip ma rd
Console#
To Next Page
Loading...
Need help?
General
