C
HAPTER
35
| ERPS Commands
– 1119 –
c. An ring node with a local manual switch command that receives an
R-APS message or a local request of higher priority than R-APS (MS)
clear its manual switch request. The ring node then processes the
new higher priority request.
◆ Recovery for manual switching under revertive and non-revertive mode
is described under the Command Usage section for the non-revertive
command.
EXAMPLE
Console#erps manual-switch domain r&d west
Console#
show erps This command displays status information for all configured rings, or for a
specified ring
SYNTAX
show erps [domain ring-name] [statistics]
domain - Keyword to display ERPS ring configuration settings.
ring-name - Name of a specific ERPS ring. (Range: 1-32 characters)
statistics - Keyword to display ERPS ring statistics.
COMMAND MODE
Privileged Exec
EXAMPLE
This example displays a summary of all the ERPS rings configured on the
switch.
Console#show erps
ERPS Status : Enabled
Number of ERPS Domains : 1
Domain ID Enabled Ver MEL Ctrl VLAN State Type Revertive
------------ --- ------- --- --- --------- ---------- ------------ ---------
r&d 1 Yes 2 1 1 Idle RPL Owner Yes
W/E Interface Port State Local SF Local FS Local MS MEP RPL
---- --------- ---------- -------- -------- -------- ---- ---
West Eth 1/ 1 Blocking No No No Yes
East Eth 1/ 3 Forwarding No No No No
Console#
To Next Page
Loading...
