Edge-Core ES3528MV2

C HAPTER 4 | Basic Management Tasks
Configuring Telnet Settings
– 140 –
N OTE : The password for the console connection can only be configured
through the CLI (see "password" on page 733).
N OTE : Password checking can be enabled or disabled for logging in to the
console connection (see "login" on page 731). You can select
authentication by a single global password as configured for the password
command, or by passwords set up for specific user-name accounts. The
default is for local passwords configured on the switch.
WEB INTERFACE
To configure parameters for the console port:
1. Click System, then Console.
2. Specify the connection parameters as required.
3. Click Apply
Figure 21: Console Port Settings
CONFIGURING TELNET SETTINGS
Use the System > Telnet menu to configure parameters for accessing the
CLI over a Telnet connection. You can access the onboard configuration
program over the network using Telnet (i.e., a virtual terminal).
Management access via Telnet can be enabled/disabled and other
parameters set, including the TCP port number, time outs, and a password.
Note that the password is only configurable through the CLI.) These
parameters can be configured via the web or CLI interface.
CLI REFERENCES
◆ "Line" on page 728
◆ "Telnet Server" on page 836