C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv6
– 1288 –
clear mvr6 groups
dynamic
This command clears multicast group information dynamically learned
through MVR6.
SYNTAX
clear mvr6 groups dynamic [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
COMMAND MODE
Privileged Exec
COMMAND USAGE
This command only clears entries learned though MVR6. Statically
configured multicast addresses are not cleared.
EXAMPLE
Console#clear mvr6 groups dynamic
Console#
clear mvr6 statistics Use this command to clear the MVR6 statistics.
SYNTAX
clear mvr6 statistics [interface {ethernet unit/port |
port-channel channel-id | vlan vlan-id}]
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4094)
COMMAND MODE
Privileged Exec
COMMAND USAGE
If the interface option is not used then all MVR6 statistics are cleared.
Otherwise using the interface option will only clear the MVR6 statistics of
the specified interface.
EXAMPLE
The following shows how to clear all the MVR6 statistics:
Console#clear mvr6 statistics
Console#
To Next Page
Loading...
Need help?
General
