C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv6
– 1279 –
mvr6 domain This command enables Multicast VLAN Registration (MVR) for a specific
domain. Use the no form of this command to disable MVR for a domain.
SYNTAX
[no] mvr6 domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
When MVR6 is enabled on a domain, any multicast data associated with an
MVR6 group is sent from all designated source ports, to all receiver ports
that have registered to receive data from that multicast group.
EXAMPLE
The following example enables MVR for domain 1:
Console(config)#mvr6 domain 1
Console(config)#
mvr6 profile This command maps a range of MVR group addresses to a profile. Use the
no form of this command to remove the profile.
SYNTAX
mvr6 profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv6 address for an MVR multicast
group. This parameter must be a full IPv6 address including the
network prefix and host address bits.
end-ip-address - Ending IPv6 address for an MVR multicast group.
This parameter must be a full IPv6 address including the network
prefix and host address bits.
DEFAULT SETTING
No profiles are defined
COMMAND MODE
Global Configuration
To Next Page
Loading...
Need help?
General
