C
HAPTER
39
| Multicast Filtering Commands
MLD Filtering and Throttling
– 1251 –
ipv6 mld profile This command creates an MLD filter profile number and enters MLD profile
configuration mode. Use the no form to delete a profile number.
SYNTAX
[no] ipv6 mld profile profile-number
profile-number - An MLD filter profile number.
(Range: 1-4294967295)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
A profile defines the multicast groups that a subscriber is permitted or
denied to join. The same profile can be applied to many interfaces, but only
one profile can be assigned to one interface. Each profile has only one
access mode; either permit or deny.
EXAMPLE
Console(config)#ipv6 mld profile 19
Console(config-mld-profile)#
RELATED COMMANDS
show ipv6 mld profile
permit, deny This command sets the access mode for an MLD filter profile. Use the no
form to delete a profile number.
SYNTAX
{permit | deny}
DEFAULT SETTING
deny
COMMAND MODE
MLD Profile Configuration
COMMAND USAGE
â—† Each profile has only one access mode; either permit or deny.
â—† When the access mode is set to permit, MLD join reports are processed
when a multicast group falls within the controlled range. When the
access mode is set to deny, MLD join reports are only processed when a
multicast group is not in the controlled range.
To Next Page
Loading...
Need help?
General
