C
HAPTER
41
| CFM Commands
Defining CFM Structures
– 1337 –
show ethernet cfm
maintenance-points
remote detail
This command displays detailed CFM information about a remote MEP in
the continuity check database.
SYNTAX
show ethernet cfm maintenance-points remote detail
{mac mac-address | mpid mpid}
[domain domain-name | level level-id | ma ma-name]
mac-address – MAC address of a remote maintenance point.
This address can be entered in either of the following formats: xx-
xx-xx-xx-xx-xx or xxxxxxxxxxxx
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
level-id – Authorized maintenance level for this domain.
(Range: 0-7)
ma-name – Maintenance association name. (Range: 1-43
alphanumeric characters)
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
COMMAND USAGE
Use the mpid keyword with this command to display information about a
specific maintenance point, or use the mac keyword to display information
about all maintenance points that have the specified MAC address.
EXAMPLE
This example shows detailed information about the remote MEP designated
by MPID 2.
Console#show ethernet cfm maintenance-points remote detail mpid 2
MAC Address : 00-0D-54-FC-A2-73
Domain/Level : voip / 3
MA Name : rd
Primary VLAN : 1
MPID : 2
Incoming Port : Eth 1/ 2
Suppress Alarm Shows if the specified MEP is configured to suppress sending frames
containing AIS information following the detection of defect
conditions.
Suppressing Alarms Shows if the specified MEP is currently suppressing sending frames
containing AIS information following the detection of defect
conditions.
Table 179: show ethernet cfm maintenance-points local detail mep - display
Field Description
To Next Page
Loading...
Need help?
General
