C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 543 –
Figure 312: Showing Detailed Information on Local MEPs
DISPLAYING
LOCAL MIPS
Use the Administration > CFM > Show Information (Show Local MIP) page
to show the MIPs on this device discovered by the CFM protocol. (For a
description of MIPs, refer to the Command Usage section under
"Configuring CFM Maintenance Domains".)
CLI REFERENCES
◆ "show ethernet cfm maintenance-points local" on page 1334
PARAMETERS
These parameters are displayed:
◆ MD Name – Maintenance domain name.
◆ Level – Authorized maintenance level for this domain.
◆ MA Name – Maintenance association name.
◆ Primary VLAN – Service VLAN ID.
◆ Interface – Physical interface of this entry (either a port or trunk).
To Next Page
Loading...
