C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 542 –
◆ CC Status – Shows if the MEP will generate CCM messages.
◆ MAC Address – MAC address of the local maintenance point. (If a CCM
for the specified remote MEP has never been received or the local MEP
record times out, the address will be set to the initial value of all Fs.)
◆ Defect Condition – Shows the defect detected on the MEP.
◆ Received RDI – Receive status of remote defect indication (RDI)
messages on the MEP.
◆ AIS Status – Shows if MEPs within the specified MA are enabled to
send frames with AIS information following detection of defect
conditions.
◆ AIS Period – The interval at which AIS information is sent.
◆ AIS Transmit Level – The maintenance level at which AIS information
will be sent for the specified MEP.
◆ Suppress Alarm – Shows if the specified MEP is configured to
suppress sending frames containing AIS information following the
detection of defect conditions.
◆ Suppressing Alarms – Shows if the specified MEP is currently
suppressing sending frames containing AIS information following the
detection of defect conditions.
WEB INTERFACE
To show detailed information for the MEPs configured on this device:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Local MEP Details from the Action list.
4. Select an entry from MD Index and MA Index.
5. Select a MEP ID.
To Next Page
Loading...
Need help?
General
