C
HAPTER
15
| IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 571 –
CONFIGURING THE
IPV6 DEFAULT
GATEWAY
Use the IP > IPv6 Configuration (Configure Global) page to configure an
IPv6 default gateway for the switch.
CLI REFERENCES
â—† "ipv6 default-gateway" on page 1405
PARAMETERS
These parameters are displayed:
◆ Default Gateway – Sets the IPv6 address of the default next hop
router.
â–
An IPv6 default gateway must be defined if the management station
is located in a different IPv6 segment.
â–
An IPv6 default gateway can only be successfully set when a
network interface that directly connects to the gateway has been
configured on the switch.
WEB INTERFACE
To configure an IPv6 default gateway for the switch:
1. Click IP, IPv6 Configuration.
2. Select Configure Global from the Action list.
3. Enter the IPv6 default gateway.
4. Click Apply.
Figure 333: Configuring the IPv6 Default Gateway
CONFIGURING IPV6
INTERFACE SETTINGS
Use the IP > IPv6 Configuration (Configure Interface) page to configure
general IPv6 settings for the selected VLAN, including auto-configuration of
a global unicast interface address, explicit configuration of a link local
interface address, the MTU size, and neighbor discovery protocol settings
for duplicate address detection and the neighbor solicitation interval.
CLI REFERENCES
â—† "IPv6 Interface" on page 1404
â—† "DHCP Client" on page 1383
COMMAND USAGE
â—† The switch must always be configured with a link-local address. The
switch’s address auto-configuration function will automatically create a
To Next Page
Loading...
Need help?
General
