Edge-Core ES3528MV2 - Snmp-Server Enable Port-Traps Atc Broadcast-Control-Apply

C HAPTER 30 | Congestion Control Commands
Automatic Traffic Control Commands
– 1041 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-fire
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-fire-threshold (1038)
snmp-server enable
port-traps atc
broadcast-control-
apply
This command sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer expires. Use the
no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc broadcast-control-apply
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-apply
Console(config-if)#
RELATED COMMANDS
auto-traffic-control alarm-fire-threshold (1038)
auto-traffic-control apply-timer (1034)
snmp-server enable
port-traps atc
broadcast-control-
release
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered and the
release timer expires. Use the no form to disable this trap.
SYNTAX
[no] snmp-server enable port-traps atc broadcast-control-
release
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)