C
HAPTER
24
| Authentication Commands
PPPoE Intermediate Agent
– 865 –
TELNET-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
Console#
PPPOE INTERMEDIATE AGENT
This section describes commands used to configure the PPPoE Intermediate
Agent (PPPoE IA) relay parameters required for passing authentication
messages between a client and broadband remote access servers.
pppoe
intermediate-agent
This command enables the PPPoE Intermediate Agent globally on the
switch. Use the no form to disable this feature.
SYNTAX
[no] pppoe intermediate-agent
DEFAULT SETTING
Disabled
Table 84: PPPoE Intermediate Agent Commands
Command Function Mode
pppoe
intermediate-agent
Enables the PPPoE IA globally on the switch GC
pppoe
intermediate-agent
format-type
Sets the access node identifier and generic error
message for the switch
GC
pppoe
intermediate-agent port-
enable
Enables the PPPoE IA on an interface IC
pppoe
intermediate-agent port-
format-type
Sets the circuit-id or remote-id for an interface IC
pppoe
intermediate-agent trust
Sets the trust mode for an interface IC
pppoe
intermediate-agent
vendor-tag strip
Enables the stripping of vendor tags from PPPoE
Discovery packets sent from a PPPoE server
IC
clear pppoe intermediate-
agent statistics
Clears PPPoE IA statistics PE
show pppoe
intermediate-agent info
Displays PPPoE IA configuration settings PE
show pppoe
intermediate-agent
statistics
Displays PPPoE IA statistics PE
To Next Page
Loading...
