C
HAPTER
42
| OAM Commands
– 1371 –
show efm oam
remote-loopback
interface
This command displays the results of an OAM remote loopback test.
SYNTAX
show efm oam remote-loopback interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-28)
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show efm oam remote-loopback interface 1/1
Port OAM loopback Tx OAM loopback Rx Loss Rate
---- --------------- --------------- ---------
1/1 10000 9999 0.01 %
Console#
show efm oam
status interface
This command displays OAM configuration settings and event counters.
SYNTAX
show efm oam status interface [interface-list] [brief]
interface - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-28)
brief - Displays a brief list of OAM configuration states.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show efm oam status interface 1/1
OAM information of Eth 1/1:
Basic Information:
Admin State : Enabled
Operation State : Operational
Mode : Active
Remote Loopback : Disabled
Remote Loopback Status : No loopback
Dying Gasp : Enabled
Critical Event : Enabled
Link Monitor (Errored Frame) : Enabled
To Next Page
Loading...
Need help?
General
