Edge-Core ES3528MV2 - Displaying Fault Notification Settings

C HAPTER 14 | Basic Administration Protocols
Connectivity Fault Management
– 549 –
Figure 316: Showing the Link Trace Cache
DISPLAYING FAULT
NOTIFICATION
SETTINGS
Use the Administration > CFM > Show Information (Show Fault Notification
Generator) page to display configuration settings for the fault notification
generator.
CLI REFERENCES
◆ "show ethernet cfm fault-notify-generator" on page 1357
PARAMETERS
These parameters are displayed:
◆ MEP ID – Maintenance end point identifier.
◆ MD Name – Maintenance domain name.
◆ MA Name – Maintenance association name.
◆ Highest Defect – The highest defect that will generate a fault alarm.
(This is disabled by default.)
◆ Lowest Alarm – The lowest defect that will generate a fault alarm
12
.
◆ Alarm Time – The time a defect must exist before a fault alarm is
issued
12
.
◆ Reset Time – The time after a fault alarm has been issued, and no
defect exists, before another fault alarm can be issued
12
.
12. See "Configuring CFM Maintenance Domains" on page 521.